Room Alert Firmware Updates

AVTECH have recently released a number of firmware updates for the following Room Alert models: Room Alert 3E, Room Alert 4E, 4ER, Room Alert 12E, 12ER and Room Alert 32W.

Please note: if you are using AVTECH Device ManageR you must use version 6.2.0 or higher in order to use these updates.

Room Alert 3E v2.0.4 Firmware Update

Room Alert 4E v4.0.4 Firmware Update

• Updated the GoToMyDevices push logic to send an automatic push when Light Tower or Relay outputs are toggled via the web interface.
• Resolved an issue that could cause Device ManageR to interpret closed switch sensors as open immediately after a device reboots.
• Resolved an issue that could cause custom MTU settings to be ignored by the network driver.
• Resolved an issue that could cause custom time servers to be ignored and replaced with time.nist.gov.
• Resolved an issue that could cause getData.json to stop loading with certain ping monitoring configurations.
• Resolved an issue that prevented custom labels for Temperature and Analog sensors from saving.
• Updated the validation on the ‘Device ManageR Server IP Address’ setting so it will not allow ‘0.0.0.0’ to be saved.
• Minor web interface display fixes.

Room Alert 12E v3.0.4 Firmware Update

• Updated the GoToMyDevices push logic to send an automatic push when Light Tower or Relay outputs are toggled via the web interface.
• Resolved an issue that could cause Device ManageR to interpret closed switch sensors as open immediately after a device reboots.
• Resolved an issue that could cause custom MTU settings to be ignored by the network driver.
• Resolved an issue that could cause custom time servers to be ignored and replaced with time.nist.gov.
• Updated the validation on the ‘Device ManageR Server IP Address’ setting so it will not allow ‘0.0.0.0’ to be saved.
• Resolved an issue that could cause a duplicate GTMD push to be sent on startup.
• Minor web interface display fixes.

Room Alert 32W v3.0.4 Firmware Update

• Updated the GoToMyDevices push logic to send an automatic push when Light Tower or Relay outputs are toggled via the web interface.
• Resolved an issue that could cause Device ManageR to interpret closed switch sensors as open immediately after a device reboots.
• Resolved an issue that could cause custom MTU settings to be ignored by the network driver.
• Resolved an issue that could cause custom time servers to be ignored and replaced with time.nist.gov.
• Updated the validation on the ‘Device ManageR Server IP Address’ setting so it will not allow ‘0.0.0.0’ to be saved.
• Updated the alarm checking logic so it can send a new alert when a disconnected sensor is plugged back in if necessary.
• Reduced the alarm clear hysteresis on analog sensor alarms to 0.10 V.
• Resolved an issue that could prevent changes to the WiSH Sensor blacklist from being applied correctly.
• Minor web interface display fixes.

In order to access these firmware updates you will need to a current GoToMyDevices.com subscription at least to the Professional level or above. If you need to upgrade your subscription, please get in touch.